Microlab GPSS216, Быстрый старт

Страница: 2 / 10

Microlab, A Wireless Telecom Group Company, 25 Eastmans Road, Parsippany, NJ 07054
Tel: (973) 386-9696 • sales@microlabtech.com • www.microlabtech.com • Fax: (973) 386-9191
GPSS216 Quick Start Guide
Lossless GPS Signal Splitter, 16 RF Ouput
Rev 2
Unpacking and Inspection
GPSS216 - Front and Rear Panels
Note: Product appearance varies by model
Antenna
Status
LEDs
Carefully unpack the GPSS216 remote unit
and check for damaged or missing parts. The
remote unit ships with the following:
• GPSS216 Head-End Unit (1RU EIA Rack)
• PSM-129 Pre-assembled connector power
cable (72” long)
• Quick Start Guide
Microlab’s Lossless GPS Signal Splitters can be used to distribute UTC synchronization to up to 32 remote units
located where the GPS signals are not readily available. The GPS signal quality is actively monitored by this system
and can be combined other Microlab Lossless GPS Signal Splitters to expand the RF outputs. It offers 16-channel
and 32-channel options.
Gain
Switch
Introduction
Model Description
GPSS216 Lossless GPS signal splitter, 2RF inputs, 16 RF output, 1RU
GPSS232 Lossless GPS signal splitter, 2RF inputs, 32 RF output, 2RU
Hardware Needed
The following items are recommended for Setup and opera -
tion:
• Four (4) screws/washers (consult your rack requirements)
• Screwdriver
• -48/+24VDC power supply with included power cable
•
TA-1MF SMA(m) terminations for each unused output
port (Recommended)
GPS Signal Splitter Models
Power
Switch
RF Outputs
SMA (f)
Alarms
Inputs
DC Power
Module
Ground Post
Rear Panel
Front Panel
Factory
Debug
Antenna
Inputs
SMA Female