micro
HAM ©
2019
All rights reserved
6 – SETUP MENU
The Setup Menu provides a very convenient way to configure the DXP interface functions without
opening the DXP or using any computer program. Each menu item has a scrolling help on the display’s
top line, thus you won't need to resort to the manual - AFTER you read the following chapter at least
once :-)!
To enter the Setup Menu press the TX and RX buttons at the same time. Use the same “two button”
press to leave setup. Setup is divided to numbered individual menu items; to switch between menu
items press either the RX or TX button. To change menu content, turn the knob. Menu 1.1 is an
exception, the selected CAT interface must be confirmed by pressing the knob, and then leaving that
menu item or leaving the menu entirely. Functions in other menu items change instantly, as the knob is
turned.
1.1 CAT TYPE
•
selects hardware levels of CAT interface.
•
NONE/RS232/IF232/FIF232/CI-V
NOTE:
The Selection must be confirmed by pressing the knob and leaving the menu item!
1.2 CAT DTR
•
selects the function of the CAT port DTR signal
•
NONE/PTT
Recommendation: use as PTT with loggers supporting DTR PTT on CAT port
1.3 WINKEY DTR
•
selects WinKey port, DTR signal functionality
•
NONE/CW/PTT
Use as the CW source with loggers that do not support WinKey
1.4 FSK DTR
•
selects FSK port, DTR signal functionality
•
NONE/FSK/PTT
Use as the PTT source with loggers that support FSK UART, e.g. MMTTY
2.1 QCW
•
enables/disables right audio channel for CW keying
•
NO/YES
2.2 PFSK
•
enables right audio channel for FSK keying
•
NO/YES
3.1 FSK INVERT
•
inverts FSK keying output
•
NO/YES
3.2 FSK 45Baud
•
select output data rate for 45Baud RTTY speed
•
45.00/45.45
Use 45.45. Computer has no way to select exact 45.45 Baud rate speed, only 45.00. By setting this
option to 45.45, DXP will very accurately resample 45.00 to 45.45 Baud which is the standard for
amateur radio RTTY operation.
13