DMX Operation Continued
Channel 1 is master DMX Channel
. This is used to put the unit in sound active
mode, DMX512 Image Mode 1, DMX Image Mode 2, Auto and Blackout. Please
see the values in the chart above for desired effect.
Channel 2 Control
: This channel gives user ability to select the Images. In
order to have access to Images using Channel 2, Channel 1 must be set to a
value between 51-101.
Note:
In this mode Channels 3 to 8 are inactive.
Channel 3 Control
: To access all single Images on Channel 3, Channel 1 must
be set to a value between 102-152.
Note:
In this mode Channel 2 is inactive.
Channels 4 to 8 are used to control the individual Images as selected.
Channel 4 Control
: When Channel 3 is available (as described in section 3
above) Channel 4 allows you to Zoom single Images IN and OUT (control size)
which have been selected on Channel 3. If Channel 4 value is at 0 most Images
will appear as a dot, therefore it is important to select a value greater than 19 in
order to see the required Image.
Channel 5 Control
: When Channel 3 is available (as described in section 3
above) Channel 5 will allow you to control the rotation of the single Image
selected on Channel 3.
Channel 6 Control
: When Channel 3 is available (as described in section 3
above) Channel 6 will allow you to move the single Image on it’s X axis (left to
right). Value 0 will take Image back to the centre or home position.
Channel 7 Control:
When Channel 3 is available (as described in section 3
above) Channel 7 will allow you to move the single Image on it’s Y axis (up to
down). Value 0 will take Image back to the centre or home position.
Channel 8 Control
: When Channel 3 is available (as described in section 3
above) Channel 8 will control the scanning speed of the single Image selected on
Channel 3.
