16
6
Normal Operation
Once installed, you can operate the Energy Pak simply by turning it on/off. It must be turned on to supply
power or to charge. The Energy Pak should be turned off during installation, when connecting/disconnecting
wires, and for long-term storage.
To turn ON the Energy Pak for charge & discharge (regular) operation
1.
Turn the Standby switch to the ON position
2.
Press and hold the Wake Up button for approximately 5 seconds. Release the button after a click
sound is heard.
3.
The Energy Pak is now turned on and can be used for normal charge and discharge operations. This
can be confirmed by checking that the Voltage Display has illuminated.
To turn OFF the Energy Pak for disconnecting & storing
1.
Turn the Standby switch to the OFF position.
2.
The Energy Pak is now turned off. This can be confirmed by checking that the Voltage Display is no
longer illuminated.
Charging your Energy Pak
You can charge the Energy Pak by connecting a power source to the battery terminals. Some common
sources of charging power are listed below. In each case, connect your power source to a charger, then
connect the outputs of your charger to the battery terminals on the front panel of the Energy Pak.
•
Grid power connected to a charger
•
Solar panels connected to a charge controller
•
Vehicle alternator or boat alternator connected to a charger
•
Wind turbine or hydro turbine connected to a charger
DO NOT OVERLOAD your Energy Pak
Always operate your Energy Pak within the permitted current limit to prevent overload. When overloading
occurs, the Energy Pak will automatically shut down as a safety precaution, and will have to go through a
restart procedure. The current limit for all models is 250 A.
Содержание Energy Pak 12
Страница 2: ...1 ...
Страница 9: ...8 Figure 3b Front Panel components of the 12 kWh Energy Pak ...
