Series 3600
9
Microframe Corporation
1.800.635.3811
Before permanent installation, we recommend that you test your entire system in one room on a table or floor.
This will be beneficial in troubleshooting should you have any problem during installation.
STEP 1: CONNECT THE ANTENNA
Connect the 90 degree antenna to the BNC connector located at the side of the transmitter. Maintain the antenna
in an upright position; this important for optimizing the range of the transmitter.
STEP 2: CONNECT THE POWER ADAPTER
Connect the supplied AC power adapter (see Figure 2). The transmitter will automatically come on. When the
transmitter is first powered up, the system will display the following screen for a few seconds:
Followed by:
The transmitter is now ready for operation.
PRECAUTIONS
Avoid placing the transmitter in the immediate vicinity of telephones, exchanges, or computer equipment. A few
feet can make a great difference in avoiding interference from the radio frequency generated by the transmitter.
The performance of your system will be effected by: foil backed wallboard, metal mesh, wire-reinforced glass,
metal sheeting, large mirrors, suspended ceilings, elevator shafts, etc. These can all reflect and thereby reduce
the signaling capability of the transmitter.
Transmitter Installation
IMPORTANT NOTE:
Use only the power adapter included with your system! The use of unapproved power adapters will invalidate
all warranty and service. We also recommend using a surge suppressor for protection. Power surges are not
covered under the warranty.
Caution: Transmitting without the antenna can damage the transmitter. Ensure that the antenna is connected
before powering the unit.