MICROENER MM30-DK, Руководство по эксплуатации

Страница: 25 / 36

MM30-DK
Doc. N° MO-0050-ING
Rev. 2
Pag. 25 of 36
Copyright - 2010 - Microener
12.2 - PROGRAMMING THE CONFIGURATION OF OUTPUT RELAYS
Mode PROG menu F

RELAY (Settings out of production are here under shown).
The key " + " operates as cursor; it moves through the digits corresponding to the four relays programmable for any
functions in the sequence 4-3-2-1-L-K-J-I-H-G-F-E-D-C-B-A (4=Relay R4 etc.) and makes start flashing the
information actually present in the digit. The information present in the digit can be either the number/letter of the
relay (if this was already associated to the function actually on programming) or a dot (-) if this place was not yet
addressed.
Display Description
Only for Version
MM30-DKX
T> ---1
Overload tripping operates relay R1, R2, R3, R4
RA,RB

RL
Ta ---- Overload prealarm tripping operates relay R1, R2, R3, R4
RA,RB

RL
ITr ----
Starting switch-over tripping operates relay R1, R2, R3, R4
RA,RB

RL
StNo ---1
Start No limitation tripping operates relay R1, R2, R3, R4
RA,RB

RL
ILR ---1 Locked Rotor tripping operates relay R1, R2, R3, R4
RA,RB

RL
tI2> ---1 Time delayed unbalance tripping operates relay R1, R2, R3, R4
RA,RB

RL
I< ----
No load running tripping operates relay R1, R2, R3, R4
RA,RB

RL
I> ----
Instantaneous overcurrent tripping operates relay R1, R2, R3, R4
RA,RB

RL
tI> ---2 Time delayed overcurrent tripping operates relay R1, R2, R3, R4
RA,RB

RL
O> ---- Instantaneous earth fault tripping operates relay R1, R2, R3, R4
RA,RB

RL
tO> ---2
Time delayed earth fault tripping operates relay R1, R2, R3, R4
RA,RB

RL
RT ----
Remote trip command (input 1-2) operates relay R1, R2, R3, R4
RA,RB

RL
1

---1
Time delayed Phase loss tripping operates relay R1, R2, R3, R4
RA,RB

RL
I> - 2 - 4
This dash means
that output relay
number 1 is not
assigned to this
element
This is the name of
protective element
The number 2
means that
output relay 2 will
operate when
this element trips
This dash means
that output relay
number 3 is not
assigned to this
element
The number 4 means
that output relay 4 will
operate when this
element trips