Microcom 438TC, Руководство оператора

Страница: 128 / 242

Chapter 5 Printer Commands
438TC Operator’s Manual - 880050-0100 5-61
command is a volatile command with a default of 0. The ^A1^D145 command
lists the current setting under the Post Takeup Time.
^A ^D COMMAND
0 157 0
1 25 25 msec
2 50
3 75
4 100
5 125
6 150
7 175
8 200
9 225
10 250
11 275
12 300
13 325
14 350
15 375
16 400
17 425
18 450
19 475
20 500
21 525
22 550
23 575
24 600
25 625
X 159 Brownout Reporting:
A brownout condition is a sag or drop in the supply voltage that dips below
16.4Vdc but does not continue to sag and perhaps goes back to the 24Vdc
supply voltage. The printer will attempt to update its configuration and
counters in this condition. Proper power sources should not normally have
situations were Brownouts are a frequent occurrence. The printer provides the
ability to monitor these types of conditions using the D159 command. The
D159 command provides a volatile or running total of the brownouts and a
non-volatile count that is saved.
0 After a power up, reports the “running” total of detected Brownouts.
1 Clears the “running” total or volatile brownout count
5 Reports the non-volatile brownout count stored in memory
255 Clears the non-volatile brownout count stored in memory
163 Sensor Status Byte: This command is used to report the real time sensor
status of all the printer sensors. When the ^D163 command is issued, the
printer returns a byte status that is defined below.