–
–
–
9.7.1
Provisioning T1 Output
This section describes how to provision a T1/E1/J1 Port to output a T1 signal.
1.
Select Output
Select 'T1' from the 'SELECT OUTPUT' dropdown. This will reveal the T1 specific configuration options.
Note:
As the T1/E1/J1 ports must both output the same signal type (T1, J1, or E1), the signal output type for
both ports is only configurable in the port 1 configuration window.
2.
Enable Port
Select 'ENABLE SIGNAL (LOW IMPEDANCE)' from the 'HIGH IMPEDANCE OUTPUT' radio buttons. This will
reveal the T1 output specific settings.
3.
Select Framing Format
Select the appropriate 'FRAMING FORMAT' option from the 'FRAMING FORMAT' dropdown. By default the
'FRAMING FORMAT' is set to none.
4.
Select Waveform Shaper
Select the appropriate waveform shaper from the 'WAVEFORM SHAPER' dropdown. By default, the
'WAVEFORM SHAPER' is set to 0-133 ft
Provisioning
©
2022 Microchip Technology Inc.
and its subsidiaries
Manual
DS00004572A-page 155
