EV20F92A Serial Memory SPI Evaluation Kit
User’s Guide
DS20006685A-page 36
2022 Microchip Technology Inc. and its subsidiaries
4.4
FLIP SOFTWARE UTILITY
Once the USB Base Board has DFU mode enabled and the COM port is relearned by
the PC, perform the following sequence using the FLIP Software Utility to update the
USB Base Board firmware:
1. Open the FLIP Software Utility (
) by either selecting the desktop icon
(if created) or selecting “Flip 3.4.7” (3.4.7 indicates the version) from the Start
Menu folder.
FIGURE 4-4:
FLIP SOFTWARE UTILITY
2. After opening the FLIP Software Utility, navigate to the Device Selection icon as
shown below. Select the “AT90USB1287” as the device and press the
OK
button.
FIGURE 4-5:
DEVICE SELECTION
Device
Selection icon
AT90USB1287
