Microchip Technology dsPICDEM MCHV, Руководство пользователя

Страница: 24 / 64

dsPICDEM™ MCHV Development System User’s Guide
DS70605A-page 18

2009 Microchip Technology Inc.
3. Connect the communication ports.
a) If R-S32 communication is used, connect the DB9 male connector to the
RS-232 port. Connect the other end to the host PC (12 in Figure 2-5).
b) If USB communication is used, connect the mini-USB male terminal to the
mini-USB female connector labeled “USB” (12 in Figure 2-5). Connect the
other end to the host PC.
4. Connect the SKDE cable. Connect the USB cable to the mini USB female
connector labeled “Program/Debug” (14 in Figure 2-5). Connect the USB male
terminal to the USB ports of the host PC.
5. Power Cord connection. Make sure the power cord is disconnected from the AC
mains before connecting the female terminal of the power cable to the AC input
connector (1, 2, and 3 in Figure 2-53) of the dsPICDEM™ MCHV Development
System.
Note: The Microchip serial emulator driver (
mchpcdc.inf
) should be installed on
you PC in order to activate the USB-to-Serial emulator. The emulator driver
is contained in the CD shipped with the dsPICDEM™ MCHV Development
System.
Note: The built-in programmer/debugger is supported in MPLAB IDE 8.33 or
higher.
Note: The unit is designed to be connected to the AC mains supply via a standard
non-locking plug. As the unit has no mains switch, this plug constitutes the
means of disconnection from the supply. Therefore, the user must have
unobstructed access to this plug during operation.