4.
Embedded Mode Quick Demo
This section provides a quick demo to stream audio using the BM83 module in Embedded mode.
Perform the following steps:
Note:
The BM83 EVB is preconfigured for the Embedded mode quick demo.
1.
Unbox the kit and connect the speaker cables to the STA369BW Audio Daughter Board at CN1 and CN2, and
connect the cables to the speaker.
Figure 4-1. Speakers Connected to the STA369BW Audio Daughter Board
2.
The SW200 switch is set to 5V_USB position as shown in the following figure.
Figure 4-2. SW200 Switch Position
3.
Connect the 15V DC adapter at DC power jack P200. Notice that the Green LED (D203) and the Red LED
(D202) turn ON.
4.
Set the SW200 switch to 5V_DC position. Notice that the Green LED (D209) turns ON.
5.
Long press
MFB
button (SW701) for minimum 4-5 seconds until the Blue LED (D300) and Red LED (D301)
start blinking alternately. Observe the sound on the speakers.
6.
Release
MFB
button.
7.
Perform the following steps to pair the BM83 module with a smartphone:
7.1.
Turn ON the smartphone's Bluetooth to scan for the available devices.
7.2.
Tap on “MCHP BM83” from the scan results. Pair to connect the device.
7.3.
On successful pairing, the MCHP BM83 device must be visible under the “PAIRED DEVICES” as
shown in the following figure.
BM83 EVB
Embedded Mode Quick Demo
©
2019 Microchip Technology Inc.
User Guide
DS50002902A-page 18
