MicroBoards Technology StartREC, Справочное руководство

Страница: 14 / 42

13
2. Use the Down/Up buttons to cycle through sub-menus that contain various parameters.
3. When the display shows the sub-menu whose parameters you want to modify, press OK/Enter . (To
return to a previous display, press Cancel/Display.)
4. Use the Down/Up buttons to choose the desired parameter value.
5. Press OK/Enter to enter the changed parameter in the StartREC 400’s memory. Altered settings are
retained indefinitely unless you change them again, or load new firmware.
Following is a list of sub-menus and their parameters.
2.3.1 COPY CHANGE
This determines whether the StartREC 400 will copy, verify, or both. After pressing
OK/Enter at the
COPY CHANGE? prompt, select from the following options with the Down/Up buttons.
Note that the StartREC 400 can also verify, or copy + verify, CDs using the CD-DA format. However,
audio data entering the system via the Audio menu changes the CD’s TOC, so that it cannot be verified
against the original audio data.
§
COPY? Copies HD/CD source material to CD Recorder drives, or source CD material to HD.
§
VERIFY? Compares the contents of source and target material to make sure the copies are bit-for-bit
accurate.
§
COPY+VERIFY? Copies as with the standard Copy function, then verifies as with the standard Verify
option.
2.3.2 HD BLOCK CHANGE
The StartREC 400’s internal HD has three different storage Blocks (partitions): A, B, and C. Select the
Block containing the data you want to copy to CDs, or to which you want to write data from CD or the
audio inputs.
After pressing
OK/Enter at the HD BLOCK CHANGE? prompt, select from the following options with
the Down/Up buttons.
§
A? Chooses Block A
§
B? Chooses Block B
§
C? Chooses Block C