Orbit II Disc-to-Disc Copier Reference Manual – Revision J
39
Attachment A Orbit II Error Messages
Error Message:
Problem
Description:
!! Bad Copy!!
The copy CD is bad and will be rejected. This message may briefly appear
during any of Orbit II’s operating modes.
!!ERROR!! No CD Reader!
This message would appear during a power on self-test if the copy controller did
not locate a compatible CD Reader.
Contact
Microboards
Technology Technical Support.
!!ERROR!! No CD-R Drives!
This message would appear during a power on self-test if the copy controller did
not locate a compatible CD-R/CD-RW Writer. Contact Microboards Technology
Technical Support.
!!ERROR!! Disc is Blank!
This message would appear at the start of a copy or compare job if the copy
controller could not read the disc that is in the CD Reader. Check your master
CD, CD-R, or CD-RW discs, and try again. If this message persists, contact
Microboards Technology Technical Support.
Setup Error
The user Setup file has been corrupted. Turn the external power supply OFF,
and leave it OFF for a few moments. When you turn your Orbit II System back
ON it will reset the user Setup file to the factory default values of
Burn CD? Yes
and
52x Write? Yes
. If you are not using these default settings, make the
appropriate
System
Setup?
changes before you use your Orbit II System.
!!WARNING!! Copier
Your Orbit II System Setup has been changed to
Burn CD? No.
If you want to
proceed with the operation you selected
is in SIMULATE mode
press the
Yes
key. If you do not want to proceed in simulate mode, press the
No
key and change the
System Setup?.
