MICRO-EPSILON turboSPEED DZ140, Руководство по эксплуатации

Страница: 22 / 34

Page 22
Operation
turboSPEED DZ140
5. Operation
5.1 Connecting the Measuring System
By means of the female connector
SUPPLY OUTPUT
, the power supply for the controller is created and
signals are output simultaneously.
Install the sensor into the turbocharger and place it flush with the inner wall of the loader.
Connect the sensor, see
Fig. 1 .
Setup the power supply for the controller by using the connecting and signal cable PC140-x, cable
length x = 3, 6 or 8 m, see 4.5.2 .
The connection and signal cable has a push-pull lock on the connector side. Push-pull connections have a
very user-friendly locking mechanism. If the connector is plugged into the device, the lock claws on the con-
nector in device snap and form a reliable connection between the two parts.
Disconnection is not possible when pulling on the connector cable.
By contrast, the connector can be easily separated from the device when the outer sleeve is retracted.
Connect measuring signal displays or recorders also to the 10-pole cable socket on the controller resp.
on the PC140-x cable.
Switch on the power supply unit.
After applying the supply voltage, the controller initializes. It is shown by means of fast red-yellow-green
flashing of the
Status
LED, see Chap. 5.2 .
Set the mode and the number of blades, see Chap. 5.5.1 , see Chap. 5.5.2 .
Make sensor positioning, see Chap. 5.3 .