Page 6
Safety
FSC1/7, FSC1000
1.3
Notes on CE Marking
The following apply to the FSC1/7 and FSC1000:
- EU Directive 2014/35/EU
- EU Directive 2014/30/EU
- EU Directive 2011/65/EU, “RoHS” Category 9
Products which carry the CE mark satisfy the requirements of the EU directives cited and the European
harmonized standards (EN) listed therein. The EU Declaration of Conformity is available to the responsible
authorities according to EU Directive, article 10, at:
MICRO-EPSILON MESSTECHNIK
GmbH & Co. KG
Königbacher Straße 15
94496 Ortenburg/Germany
The measuring system is designed for use in industrial environments and meets the requirements.
1.4
Notes regarding FCC Approval
The FSC1/7 and FSC1000 are registered under the FCC identifier: 2AMBGMEMW02, equipment class
- Part 15 Class B Computing Device Peripherals and
- Part 15 Class C Low Power Communication Device Transmitter
with the US Federal Communications Commission (FCC).
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation
.
If sensor and/or controller are modified, the FCC approval becomes void.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to
part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful inter-
ference in a residential installation. This equipment generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a particular installation.
