MICRO-EPSILON colorCONTROL MFA-5, Инструкция по эксплуатации

Страница: 37 / 80

Page 37
Operation
colorCONTROL MFA-5
When opening the
Measurements
window, the color values are displayed for the 5 specified checkpoints /
color chips which have been determined using the start screen, see Fig. 25 .
Fig. 25 List of measurements window
If you would like to compare LEDs with each other, you can save the color values in the software as reference
values and compare them.
Save the determined vales for this using the Save Reference button. Load the determined vales using
the
Load Reference
button.
Now test again using the Perform Measurement button without changing the test environment.
The color values are displayed in green. This means that the software has recognised the values as refer-
ence values. It is also recommended to save the settings using Save Settings otherwise they have to be
entered again when the software is restarted.
When you replace the reference LEDs with the LEDs to be tested, and perform a new measurement using the
Perform Measurement button, the program compares the test values with the reference values, see Fig.
26 . If any difference occurs in doing so, this is displayed in red.
Archive the test result using the Save Test Report button.