MICRO-EPSILON capaNCDT 6100, Инструкция по эксплуатации

Страница: 51 / 62

Page 51
Installation and Assembly
English
capaNCDT 6100
4.5 Power Supply and Signal Output
The power supply and signal output are connected by the 8-pin built-in connector (DlN 45326). Pin assign-
ment, see
Fig. 5 . The controller contains a 8-pin cable socket for the user-side assembly of your own connec-
ting cable.
PIN Assignment
1
6
7
3
5
2
8
4
i
Requirements of-
power and output
cables to satisfy
the EMC regulati-
ons.
1 0 Volt (24 V operation)
2 +15 Volt (Option)
3 Output A displacement signal/voltage
4 -15 V (Option)
5 0 Volt (±15 V operation)
6 +24 Volt (24 V operation) Solder pin side
cable socket
7 0 Volt (analog output)
8 Output B signal option (e.g. current)
Pin assignment Fig. 5
In addition the following applies:
Use a double screened cable!
Outer screening mesh surrounds all cable wires. -
Inner screening mesh surrounds signal wires PIN 3, 7, 8. -
Inner screening mesh at pin 7. -
Total screen via connector housing to housing ground -
Recommended conductor cross-section 0.14 mm -
2
(AWG 26)
The EMC regulations, see Chap. 1.3 , are only satisfied under these basic conditions.