MICRO-EPSILON 4350127.256, Руководство по эксплуатации

Страница: 38 / 173

Page 38
Instruction Manual Software
thicknessCONTROL MTS 8202.LLT / 4350127.256
5.8.3 Views of Traversal Measurement
The single views are explained in the following paragraphs which enable measurement
data analysis of the traversal measurement. Selection of the single views is made via the
view bar.
Fig. 41 Elements of the view bar
5.8.4 Sensor View
Fig. 42 Sensor View
The actual states of both scanCONTROL sensors are shown in the initial state of the
software, see Fig. Above. Central information thereof are respectively
- the actual state of a scanner,
- the name of the scanner,
- the recorded number of scans per second,
- the number of valid points, with 640 points as maximum,
- the actual and the averaged distance value in millimeter.
By means of a bar graph that distance is represented in relation to the measuring range.
Furthermore check boxes are used to set the value visualization of each sensor which
combination from distance and intensity values
Furthermore, can be selected for the visualization of the values of each sensor on the
check boxes which combination to display of intensity values should be displayed.
5.8.5 Statistical Analysis
With retrieval of an article in the stock list, also the calculation of the statistical character-
istic values of the production is started. The following characteristic values are calculated
and displayed:
- Median, minimum, maximum and standard deviation (= sigma)
- Percentage measurements within resp. outside tolerance
- Percentage measurements within resp. outside 3 sigma
- Display of distribution of the measurement values in a histogram
- Cp and Cpk
The characteristic values are visualized in view Statistic . The three black vertical lines
mark the lower resp. upper tolerance and the setpoint.