Micro Autonomations LLC – Fan Controller v3
15
Document Rev 1.0
Choose Temperature Sensor:
This option allows selection of the installed temperature sensor to enable the use of one of the pre-set
temperature ranges. If use of a pre-set temperature range is not desired, the controller may be
programmed by setting the turn on and 75% temperature points, and ignoring this option.
Use:
1.
Press and hold
Prg
for 4 seconds, until the Status LED turns Red, then release
Prg
2.
Press
Skip
to switch between selecting the GM sensor, and the Autometer (AM) sensor
3.
Press
Prg
to save the currently selected sensor
3a. Or, hold
Skip
for 4+ seconds to exit programming without changing the previously selected
sensor
By default, when a sensor is chosen, pre-set temperature range #1 will automatically be selected and
saved. The turn on and 75% temperature points may then be selected, or a different temperature range
may be selected.
Note:
Selecting a sensor that is not installed, then selecting a temperature range will result in unexpected fan
behavior
Choose Pre-set Temperature Range:
This mode allows selection of one of three pre-selected temperature ranges, assuming the installed
temperature sensor has already been selected.
The full speed temperature will be automatically calculated from the two temperature points.
Use:
1.
Press and hold
Prg
for 6 seconds, until the Status LED turns Orange, then release
Prg
2.
Press
Skip
to switch between the three ranges
3.
Press
Prg
to save the currently selected range
3a. Or, hold
Skip
for 4+ seconds to exit programming without changing the previously selected
range
Pre-set temperature ranges available for selection:
Range #
Turn On Temperature
75% Temperature
Full Speed Temperature
Error LED color
1
170°
185°
190°
Green
2
190°
205°
210°
Red
3
200°
215°
220°
Orange
