MICRO AIR
®
XA23
CLEAN AIR SYSTEMS
!
!
2
WARNINGS:
All electrical work must be done by a
qualifi ed electrician according to local, state
and national codes.
CAUTION: Installation can cause
exposure to live components. Disconnect
electrical power before proceeding with
installation. Proper Lock Out / Tag Out
procedures should be used.
Improper installation or operation of this
equipment can cause damage to equipment
and / or injury to personnel. The
installation/operation manual must be read
and followed in its entirety.
SPECIFICATIONS:
Input Voltage:
120 VAC 1-Phase
Motor:
3/4 HP TEFC
Max Current:
10.0 Amps
Filter Area:
95-142 square feet (media
dependent)
Load Capacity:
500 pounds
Air Flow:
1800 CFM
Capture Velocity:
250 FPM average @ 1” above
work surface.
Noise level:
79 dBA at operator
74 dBA at operator with silencer
/HEPA
Overall Dimensions:
Base table: 36H x 41W x 25D
With shields: 73H x 41W x 25D
COMPRESSED AIR REQUIREMENTS:
3/4” Air line with clean, dry compressed air regulated
to 80-90 psi max is required for proper operation of the
Roto-Pulse fi lter cleaning system. It is recommended that a
pressure regulator and coalescing fi lter be installed between
the compressed air source and the inlet to the down draft
table.
EQUIPMENT/TOOLS REQUIRED:
Standard wrenches
Forklift
Pipe wrench
Cordless drill
INSTALLATION:
1. Inspect the XA23 Max for any visible damage that may
have occurred during shipment. Note any damage on
the packing slip.
2. Uncrate the unit. Use caution not to damage the paint
while dismantling the crate.
3. Remove any options ordered from the skid.
4. Using a forklift, lift the unit off of the skid. Carefully
place the downdraft table into its location.
5. Connect compressed air supply to the 3/4” NPT nipple
on the unit.
6. Plug the unit into a 120V receptacle rated for a
minimum of 15Amps.
7. Mount any optional accessories per instructions if
ordered.
OPERATION:
•
To start the unit, toggle the switch located on the front
of the unit to the ON position. To stop the unit, toggle
the switch to the OFF position.
•
If equipped: To turn the light on toggle the switch
located on the front of the unit to the ON position. To
turn the light off, toggle the switch to the OFF position.
•
To clean fi lters depress and hold down the pulse
push-button for 2 seconds at least once per hour, and
once after shutdown.
•
Units equipped with auto-pulse do not require manual
activation of the pulse system while the unit is running.
The fi lers will clean automatically for 2 seconds, every
45 seconds that the unit is running. It is recommended
that at least one manual pulse is completed after the
unit is turned off.
FIG 1.
Pulse Push Button
Electrical Plug
Light Switch
Motor Switch
Compressed Air
Connection
