Amplifier Connection
Amplifier speaker output terminals are typically
color coded with black for negative (-) and red
for positive (+). Similarly, the MB42X-C has
speaker wire terminals with a black and red
color coding. When connecting speaker wire,
ensure that the positive terminal on the amplifier
is connected to the positive terminal on the
MB42X-C. And similarly, the negative terminal
on the amplifier should be connected to the
negative terminal on the MB42X-C.
Speaker wires typically use at least one of
several possible methods to help maintain
correct polarity, including color coded insulation
or conductor strands, or printing of text and
symbols along one side of the wire insulation.
Amplifier Considerations
The MB42X-C’s impedance varies between 4 to
8 Ohms. Care must be taken to ensure that the
amplifier is capable of handling a 4-Ohm load.
Some amplifiers have a switch that must be set
to select a 4-Ohm compatible operation mode.
Improper amplifier selection or setup may result
in permanent damage to the amplifier or speaker.
The MB42X-C can be used with amplifiers
between 15 to 100 watts per channel as long as
reasonable care is exercised. If there is audible
distortion, turn down the volume until the
distortion goes away. Never allow the speaker
and amplifier to play for more than a few
seconds when there is audible distortion.
Removing the Grill
The MB42X-C has a removable grill that is held
in place by four high strength magnets. To
remove the grill, carefully pry the grill off from
edge until the magnets are fully disengaged. To
avoid damaging the speaker drivers, do not
touch them either with or without the grill in
place.
The MB42X-C can be used without the grills
installed as long as care is taken to prevent the
drivers from damage such as by hard/sharp
objects, liquids, pets, or hands. Store the grills in
a safe dry place when not in use.
MB42X-C Specifications
Woofer: Dual 4” Carbon Fiber Cone with Rubber Surround
Tweeter: 0.75” Silk Dome
Crossover: 12dB/Octave
Enclosure: Ported Cabinet
Frequency Response: 60Hz-20kHz (Typical In-Room)
Impedance: 4-8 Ohms
Sensitivity: 86dB 1W/1M
Power Handling: 100 Watts (Each)
Dimensions: 5.3” (H) x 15” (W) x 7.1” (D)
Information in this manual is believed to be accurate and reliable but Micca Ltd assumes no responsibility for its use nor for any
infringement of patents or other rights of third parties which may result from the use of this manual or the product. Micca
reserves the right to change product specifications at any time without notice.
Micca, MB42X, MB42X-C, and the Micca logo are trademarks of Micca Ltd. Other trademarks referenced in this manual are the
properties of their respective owners.
© 2012-2013 Micca Ltd. All rights reserved.
