Micanan PRO-H, Инструкция по установке и эксплуатации

Страница: 24 / 48

22
DIPSWITCH SETUP
Dip-switch ON OFF NOTE
SEQ/COM
Single button and
radio in SEQ mode Single button and
radio in COM mode
Mid-stop
timer
Timer is enabled
from mid-stop only Timer is enabled
from both mid-stop
and full open T or TS mode must be
selected to enable a timer
for mid-stop
Delay on
reverse
Delay on reverse is
1.5 seconds Delay on reverse is
0.5 seconds Micanan recommends 1.5
sec delay on reverse for all
applications
Motor
direction
Reverse motor
direction Standard motor
direction See Note ** below
NOTE : If motor direction is reversed, the open and close limit switches are automatically reversed. However, the advanced
close limit switch needs to be manually changed. To do this, disconnect the 2 wires from the advanced closed limit switch
and re-connect to the auxiliary limit switch provided.
STATUS LED
LED Status Cause
Fault ON -Primary safety devices not connected to P1 & P2
or not functioning properly
- Safety devices are activated
- 10k Ohm resistor (between S1 & S2) removed or
faulty
Fault Blinking - Interlock is activated.
- Interlock jumper is not connected.
Run-out timer ON - Run-out timer has elapsed
Delay on close timer Blinking - Delay on close timer is counting.
- Selector dial is set to Run-timer.
Timer to close Blinking Timer to close is counting.
Safety/Photo ON -Primary safety devices not connected to P1 & P2
or not functioning properly
- Safety devices are activated
- 10k Ohm resistor (between S1 & S2) removed or
faulty
Mid. Stop ON Door is at Mid-stop position.
Close Limit ON Close limit switch is activated.
Open Limit ON Open limit switch is activated.
Stop PB ON
OFF
-
Stop button connected and functioning
- Stop push button is activated (or stop circuit is
open).
Close Relay Blinking - Door is closing.
- Close relay is activated.
Open Relay Blinking - Door is opening.
- Open relay is activated.
Power ON 24 VAC power to logic board is ON.