MICA IL-800 Hand Lamp Manual
USE:
Operating switch of the IL-800 lamp has three modes: LOW POWER HIGH POWER OFF.
Operating time of the lamp after it has been fully charged depends on the mode chosen using the
switch. When there is approximately 1/2h operating time left (depending on ambient temperature and
condition of battery), the light will begin to flash every 15 seconds. In special circumstances, the lamp
can be switched on after the battery has been discharged whereupon the lamp will function for a short
period of time. We do not, however, recommend this because it shortens the lifetime of the battery.
If the lamp is used only for short periods of time between charges, we recommend that the lamp is left on
and be completely discharged after every tenth time it has been used. When the battery is discharged,
control electronics will automatically switch off the lamp in due time before there is a danger of deep
discharge in the battery cells. The battery will be charged from empty to full in approx. 5.5 hours with
MICA ILC4 Charger (depending on ambient temperature and condition of the battery).
Emergency light model (IL-800 EM):
The IL-800 EM model lamp has an emergency light mode: when placed in the charging stand it will
always remain in stand-by mode and will be switched on if mains voltage is cut off. When lamp is in EM
mode and installed to the charger the LEDs will glow dimly.
Blinking light model (IL-800 BK):
The IL-800 BK model has blinking mode instead of “low power -mode”. Operation switch of the lamps
has modes: BLINK HIGH POWER OFF.
MAINTENANCE & SPARE PARTS:
Users may replace only those parts that are listed in spare parts list and can be purchased as
spare parts from MICA dealer. Replacing other parts is allowed only by MICA SERVICE! Note
that the certification issued for the MICA IL-800 lamp requires that only original MICA spare parts
are used in the lamp.
When the battery becomes old, operating time of the lamp will become shorter. If the operating time is
disturbingly short even though the battery has been fully charged, the battery must be replaced.
Replac-
ing battery and PCB-cards is allowed only by authorized MICA SERVICE!
When performing maintenance tasks, the lamp must often be at least partially disassembled. The lamp
must be disassembled according to the instructions below:
A:
Unscrew the locking ring (1) and remove the glass lens and o-ring (2). Open three bolts (2,0mm hex
key) which hold the reflector and remove the reflector (4).
B:
Disconnect the red/black wire of the connector in LED-PCB. Open six bolts (2,0mm hex key) which
hold aluminium LED-module and remove the LED-module (5).
C:
Now you can change the parts.
Assembly:
Assemble the lamp in reverse order.
Be sure that all wires run freely! Tighten the locking
ring so that the marking (dot) on the locking ring meets
tha centerline of lamp enclosure (arrow). If necessary
apply lubricant to the locking ring thread (e.g. mineral
oil based). See
“Pic 1”
.