Note:
In order to prevent the small-capacity battery from charging with high
current, when the set current is greater than (default c0.5A) charging,
the charger will charge the battery with (default c0.5A).
Default current: The current symbol " " flashes, indicating that the charger automatically
distributes the charging current based on the battery internal resistance.
Long press , till the “ ” flashing
，
then short press
to set the charging current, you can long press to exit, or it will
exit automatically after 5 seconds.
Set the batteries type
Set the charging current
Put the batteries into any slot, and quickly double press the , then the
batteries symbol will flash, short press , you can switch the batteries type,
you can long press to exit, or it will exit automatically after 5 seconds.
Note:
The whole selection mode only effective for the slots with batteries,
can’t choose the battery type for Ni-MH/Ni-Cd during this mode.
Note:
put low Voltage batteries into charger and when the charger finished
charging
，
the mAh means the total capacity of the batteries
.
Long press , enter into check all status, All slot symbol flashing, the
charger will exit check all status within 5 seconds if there is no operation.
1. Under the check all status,long press the , you can set all slots
charging current.
2. Under the check all status,quickly double press the , you can
change all slots batteries type.
The function of seting all slots simultaneously
Put the batteries into any slot, the charger will automatic calculate the
accumulated mAh.
When “ ”, flashing
，
the mAh means accumulated mAh.
When “ ”, stays-on, mAh means the batteries capacity.
Measure the batteries capacity by charging
Li-ion / LiFePO4
Ni-MH / Ni-Cd
Charging
current range
Li-ion(4.20V / 4.35V)
Voltage < 3.4V
Voltage < 3.0V
Voltage < 1.05V
LiFePO4
Ni-MH / Ni-Cd
Low Voltage
Batteries type
0.1A / 0.2A / 0.3A / 0.5A / 0.8A /
1.0A / 1.2A / 1.5A / 2.0A / 2.5A
0.1A / 0.2A / 0.3A / 0.4A / 0.5A /
0.6A / 0.7A / 0.8A / 0.9A / 1.0A
03
