Mi-T-M MH-0042-PM11, Руководство оператора

Страница: 19 / 26

Propane Patio Heater Manual 19
NOTE: Whenever gas connections are loosened or removed, you must
perform a complete leak test.
CAUTION: DO NOT ATTEMPT TO OPERATE UNTIL YOU HAVE READ
AND UNDERSTOOD ALL GENERAL SAFETY INFORMATION IN THIS
MANUAL AND ALL ASSEMBLY IS COMPLETE AND LEAK CHECKS
HAVE BEEN PERFORMED. THIS APPLIANCE SHALL BE USED ONLY
IN A WELL-VENTILATED SPACE AND SHALL NOT BE USED IN A
BUILDING, GARAGE OR ANY OTHER ENCLOSED AREA.
An appliance may be installed with shelter no more inclusive than:
1. With walls on all sides, but with no overhead cover. Always maintain a clearance
of 1.2 m (47") from combustible materials from the top and side.
2. Within a partial enclosure which includes an overhead cover and no more than two side walls. These side
walls may be parallel, as in a breezeway, or at right angles to each other.
3. Within a partial enclosure which includes an overhead cover and three side
walls, as long as 30 percent or more of the horizontal periphery of the enclosure
is permanently open.
ASSEMBLING THE BATTERY
(AAA batteries.not included). Unscrew the black ignitor spring cover counter-
clockwise. Put the positive pole outward toward the ignitor and screw back the
balck ignitor spring coverr.
BEFORE LIGHTING
1. Heater should be thoroughly inspected before each half year use, and by a
qualified service person at least annually. If relighting a hot heater, always wait at least 5 minutes.
2. Inspect the visible portion of the hose before each use of the appliance. If the hose leaks, it must be replaced
prior to operation. Only use the replacement hose assembly specified by manufacturer.
3. The pressure regulator and hose assembly supplied with the appliance must be used. Replacement pressure
regulators and hose assemblies must be those specified by the appliance
manufacturer.
DANGER: CARBON MONOXIDE HAZARD FOR OUTDOOR USE
ONLY. NEVER USE INSIDE HOUSE, OR OTHER UNVENTILATED
OR ENCLOSED AREAS. THIS HEATER CONSUMES AIR
(OXYGEN). DO NOT USE IN UNVENTILATED OR ENCLOSED
AREAS TO AVOID ENDANGERING YOUR LIFE.
LIGHTING
1. Turn on the valve on the gas cylinder.
2. Press and turn the control knob to PILOT position (anti-clockwise 90º).
3. Holding down the control knob, press the igniter button several times until
the main flame is ignited. Release the control knob 10 seconds after the
ignition.
4. Press lightly and turn the variable control knob to HI (maximum) position and
leave it there for 5 minutes or more before turning the knob to the desired
temperature setting.
5. If the burner flame goes out, turn off the heater and wait at least 5 minutes
or more to let the gas dissipate before re-lighting to avoid gas explosion.
Repeat steps 2 to 4.
Note: Improper operation can cause injury or property damage. If pilot fails to remain
lit, all valves should be closed and you should wait for at least 5 minutes before
attempting to light it again. If you experience any ignition problem, please consult
“Troubleshooting”.
OPERATION
WA
LL
CEILING