Mi-T-M GEN-3000-iMM0, Руководство оператора

Страница: 31 / 116

Operator’s Manual 31
Service
MAINTENANCE SCHEDULE
CHANGING ENGINE OIL:
Avoid draining the engine oil immediately after stopping
the engine. The oil is hot and should be handled with
care to avoid burns.
1. Place the generator on a level surface and warm up
the engine for several minutes. The stop the engine
and turn the 3 in 1 switch knob, fuel tank cap air vent
knob to “OFF”.
2. Remove the screws and then remove the cover (Fig. 20).
3. Remove the oil filler cap (Fig. 21).
4. Place an oil pan under the engine. Tilt the generator to
drain the oil completely.
5. Replace the generator on a level surface.
6. Add engine oil to the upper level (Fig 22).
Note: Do not tilt the generator when adding engine oil. This
could result in overfilling and damage to the engine.
SERVICING THE AIR CLEANER:
Maintaining an air cleaner in proper condition is very
important. Dirt induced through improperly installed,
improperly serviced or inadequate elements damages
and wears out engines. Always keep the element clean.
1. Remove the screws, and then remove the cover (Fig. 20).
2. Remove the screw and then remove the air filter case
cover (Fig. 23).
3. Remove the foam element.
4. Wash the foam element in solvent and dry it.
5. Oil the foam element and squeeze out excess oil. The
foam element should be wet but not dripping.
(Fig. 22)
(Fig. 20)
(Fig. 21)
(Fig. 23)
screws screws
cover
Screw
Cover