4
Sensor installation
We recommend installing the floor sensor in a corrugated tube (Ø 16mm - Fig. 1) so that it can be
easily replaced in the event of a fault.
For information on how to install the floor sensor on your heater, please refer to the installation and
operating instructions of your heating mat.
Fig.1
Thermostat installation
Turn the control knob (fig. 2) to minimum temperature (OFF) and lever it off with a screwdriver (fig. 3). This is done in the direction away from
the thermostat cover. Loosen the left screw and remove the thermostat cover and the inner frame (fig. 4).
Fig. 2
Fig. 3
Fig. 4
Temperature setting
The thermostat can be set in the temperature range +5 ~ 45°C. When used with underfloor heating, the temperature must be limited and must
not exceed the temperature specified by the manufacturer of the floor covering (usually max. 27°C). The locking mechanism is located under
the control knob. With its setting, unintentional temperature changes can be avoided (e.g.: by children, hotel guests, etc.). By loosening the
small screw on the right and adjusting the limiting discs, the temperature scale can be locked (e.g. between 20°C and 25°C). The red limiting disc
indicates the maximum temperature, the green limiting disc the minimum temperature. If the floor temperature is lower than the temperature
set on the thermostat, the LED display indicates the switching of the thermostat relays. As soon as the temperature is reached, the relays switch
off and the LED display goes out.
Disposal note
Do not dispose of this appliance in household waste! Electronic devices must be disposed of in
accordance with the Waste Electrical and Electronic Equipment Directive via the local collection points
for waste electronic equipment.
Note on conformity
The CE mark is an over-the-counter mark that is addressed exclusively to the authorities and does not
imply any assurance of properties.
Documentation © 2022
Mi-Heat Heizsysteme GmbH
All rights reserved. No part of this manual may be reproduced or duplicated in any form without the written consent of the publisher. It is possible that this manual
contains typographical defects or printing errors. We accept no liability for errors of a technical or printing nature and their consequences.
Mi-Heat Heizsysteme GmbH
Ol Streek 39a
26607 Aurich
Germany
Internet:
E-Mail:
