Operating instructions MHM Digital V Pro V1_0.docx
Page 6 of 52
1.3.
Maintenance Safety Instructions
When performing any printer maintenance procedures, follow these safety instructions:
•
Always wear suitable personal protective equipment when performing printer
maintenance. Should any waste ink or cleaning agent solution come in contact with your
skin or enter your eyes or mouth, immediately take the following actions:
o
If fluid gets on to your skin, immediately wash it off using soap and water. Consult a
physician if the skin appears irritated or discolored.
o
If fluid gets in your eyes, rinse immediately with water. Failure to observe this
precaution could result in bloodshot eyes or mild inflammation. If problems persist,
consult a physician.
o
If fluid gets in your mouth, consult a physician immediately.
o
If fluid is swallowed, do not induce vomiting and consult a physician immediately. If
vomiting is induced, fluid may get caught in the trachea which can be dangerous.
o
If you notice that the cleaning agent has changed color or emits a bad odor, stop
using it and open a new cleaning agent.
o
Close the fluid lid securely after used, and store it out of reach of children. Avoid
storing it in locations subject to high temperatures, high humidity, and direct
sunlight.
o
Wash your hands thoroughly with soap and water after any fluid usage.
•
Store ink cartridges, waste ink and cleaning agent out of the reach of children.
•
Wash your hands thoroughly after performing any maintenance procedure.
•
Touch a metal object before starting operations to disperse any static electricity.
•
To prevent the print head from drying out, finish cleaning the suction cap and replacing
the head cleaning set within 10 minutes.
•
Do not touch any parts or circuit boards other than the parts you are maintaining. This
may cause a malfunction or decline in print quality.
•
Always use new cleaning swabs to avoid getting the printer parts dirty.
•
Do not touch the tip of the cleaning swabs with your hand. Oils on your hand may
compromise cleaning ability.
•
Do not use water or organic solvents such as alcohol on the suction cap or the wiper unit.
If ink is mixed with water or alcohol, it may solidify.
•
Do not wipe the suction cap with organic solvents such as alcohol. Otherwise a print
head malfunction may occur.
