ASSEMBLY INSTRUCTIONS THERMOSTATIC SHOWER CB404
2/2
ASSEMBLY OF HAND SHOWER DIVERTER BLOCK
(FIG 6)
Fully push diverter block (I) into connection (C’) taking care of not damaging O-Ring gaskets.
Tighten the assembly with ring (I’).
Place console (Z)(FIG6/a) on shower diverter (I) with reference mark (Z’) on the bottom side.
Tighten flexible hose (L) to (L’).
ASSEMBLY OF LOWER COLUMN
(FIG 7) (FIG 7/a)
Screw lower column (N) to shower diverter (I).
Screw bracket (R) onto column (N) as per drawing by hand tightening lid (S).
Screw fixing block (U) to the wall as follow:
- after placing block (U) into socket of (R) mark drilling point on wall.
- unscrew lower column (N) and fix block (U) to the wall through screw and boss (enclosed).
Unscrew lid (S) place bracket (R) as per FIG 7/a and screw lower column (N) back into position.
Block lid (S) with allen screw N°6 (enclosed).
Tighten two screws (V) with allen screw N°3 (enclosed).
ASSEMBLY OF UPPER COLUMN
(FIG 7) (FIG 7/a)
Screw upper column (M) to shower diverter assembly (I).
Insert flexible hose (L) through hole of bracket (T) and place bracket onto socket (T’).
Check verticality of assembly (I-M-N) and fix block (U) to the wall.
Tighten bracket (T) with allen screws (V) after checking correct vertical position of the shower..
ASSEMBLY SHOWER HEAD CURVE
(FIG 8) ( FIG 8/a)
- Unscrew and remove part (Q) from the end of flexible hose (L).
- Disassemble swivel head from shower curve (P) unscrewing (O’).
- Unscrew and remove part (O2).
- Insert shower curve (P) into upper column (M) without damaging the gaskets.
- Pull out flexible hose (L) from point (Q’) and fully push curve (P) into column (M).
- Screw back into position part (Q) to flexible hose (L) and fully push into (Q1).
- Screw back into position part (O2) and (O1).
CONNECTION OF HAND SHOWER
(FIG 9) (FIG 9/a)
Screw knurled nut (W) to flexible hose (L) and place hand shower on console (Z)
