MGM 100120-3, Руководство по эксплуатации

Страница: 72 / 72

72 / 72 HBC-series V7 LV+MV
Content of delivery

Controller in box

CD with program Controller 2, with manual and other information

Printed basic (general) information

Warranty certificate
Product Warranty
MGM
COMPRO
guarantees, this product to be free from factory defects in material and workmanship. Warranty period is of 24 months from
date of purchase and purchase within the EU. Warranty for purchases made outside the EU is inline with the respective legal regulations.
Warranty liability shall be limited to repairing or replacing the unit to our original specifications.
The warranty may be claimed under the following conditions:
The product has been used in the coherence with the instructions for use and only for purposes stated in the instructions and provided that
none of the conditions for which the warranty cannot be claimed (see below) occurred.
It is necessary to provide together with the product for repair:

a copy of sales receipt (if a warranty repair is claimed)

detailed description of the problem
– how it occurred and what is the problem

description of the RC set you were using when the problem occurred (number of cells, their capacity, motor, throttle, etc.)

your phone number and/or email address in order to allow further consultations regarding the problem
.
The warranty does not cover and therefore cannot be claimed for damages/destroys cause by:

forced mechanical damage, crash of the model etc.

chemical substances

unqualified manipulation, incorrect installation

any interference with the controller (soldering, change of wires, change components, exposed circuit board etc.)

reversal of poles

disconnecting from the battery (or switch-off) while the motor is still turning

overloading with a higher number of cells than specified

feeding from unspecified source (e.g. mains source instead of the specified cells)

shortcut on the output

overload

overloading BEC, shortcut BEC or servocable to feeding or motor cables

water or any other substances (except "WR" version)

salt water

running with damaged motor

operations with not recommended (not suitable) connectors

not following the instruction in the manual or operating in conflict with recommendations or manual
The warranty also does not apply when:

the connectors are cut (servocable etc.)

the controller or its parts are warn by regular use

the plastic cover (shrinking sleeve) is cut or the controller is taken out of it

acts of God (e.g. strike by lightening)
We do reserve the right to change our product warranty at any time without prior notice.
Service and Technical Support
Send product for service to address: MGM
COMPRO
, Sv. Čecha 593, 760 01 Zlín, Czech republic, EU
Call your questions and requests to: +420 577 001 350 or write on: mgm@mgm-compro.cz .
Information about products, technical notes, news, recommendation: www.mgm-compro.cz
Update firmware and SW on: www.mgm-compro.cz
Recycling
This symbol on the product and / or accompanying documents mean that used electrical and electronic products should not be mixed with
general household waste.
For proper treatment, recovery and recycling, please take these products to designated collection points, where they will be accepted on a free
of charge basis.
Electromagnetic Conformity declaration
For these products of the HBC-series family we confirm that the electromagnetic compatibility directives are met.
Development, manufacture,
service:
Tel.: +420 577 001 350
MGM
COMPRO
, Ing. G. Dvorský E-mail: mgm
@
mgm-compro.cz
Sv. Čecha 593, 760 01 Zlín, Czech Republic Info: www.mgm-compro.com