ENGLISH
ENG
CAUTION:
Read, understand and follow the Safety Guidelines and Operating
Instructions in the manual before use.
.
NOTICE: MUST HAVE EXTREME
CARE WHEN USING THIS DEVICE.
Improper use of this device may cause damage or death. All protective
measures suggested in this manual must be followed in addition to the normal
safety precautions used when working with electrical circuits. You should NOT
attempt to repair this device if you are not qualified to do so.
1. SAFETY SYMBOLS
Important safety information, see operation manual.
Grounding
2. SPECIFICATIONS
Voltage sensitivity: 90-1000VAC
Frequency: 50/60Hz
Operating temperature: -10 to 50ºC
Storage temperature: -10 to 50ºC
Indicators: Beep and flashing LED indicate that there is voltage.
It is used to detect voltage in shops, lighting, switches, cables and to find cable
breaks.
Safe, as it detects the voltage without contact.
Power supply: 2 x 1.5V AAA
Size: 148×17×26mm.
Weight: Approx. 23g (without batteries)
CAT. II 1000V according to EN61010
3. BATTERY INSTALLATION
1.Open the battery cover (end cap) by gently pulling up/down on the coupler
using a small screwdriver.
2.
I
nsert two AAA batteries (observe polarity).
3.Replace the battery cover.
NOTE: If the meter does not work properly, check the battery to make sure it is in
good condition and inserted correctly.
NOTICE
To avoid receiving an electric shock, do not use the meter until the battery
cover has been put back in place and securely fastened.
NOTICE
The measurement should only be carried out if the cap has been attached to
the tip of the probe.
5. AC VOLTAGE DETECTION
NOTICE
Risk of electrocution. Before using the device to check the voltage of a current
output, the Voltage Detector must always be tested on a known conductive
circuit to verify that the Voltage Detector is working properly.
NOTICE
Risk of electrocution. Hands and fingers should be kept at the base of the
probe, away from the tip of the probe.
To check the AC electrical voltage of a current output:
1. Connect the probe tip to a cable that is plugged into the output or insert it
into the plug itself.
2. If there is AC voltage, the detector light will flash and give an audible
warning.
Voltage detector
C-LOGIC 25
SKU: CLOGIC25CBINT
INSTRUCTION MANUAL
4. OPERATING INSTRUCTIONS
NOTICE
Risk of electrocution. High voltage circuits, both AC and DC, are
very dangerous and must be measured very carefully.
COMPLETE MANUAL DOWNLOAD
You can download the complete manual at the URL:
https://clogic-intl.com/clogic-25
MANUFACTURER: MGL International
APAC:
MGL GLOBAL SOLUTIONS LTD
Flat 4-1, 4/F, No. 35, Section 3 Minquan
East Road. Taipei, Taiwan.
Tel: +886 2-2508-0877
EMEA:
MGL EUMAN S.L.
Parque Empresarial Argame, 33163
Morcín. Asturias, Spain.
Tel: +34 985-08-18-70
AMERICAS:
MGL AMERICA, LLC.
US East Coast:
2810 Coliseum Centre
Drive, Ste. 100. Charlotte, North Carolina,
28217 USA
Tel: +1 833 533-5899
US West Coast:
760 Challenger Street.
Brea, California 92821 USA
Tel: +1 310-728-6220
www.mgl-intl.com
