S Button:
Adjust intensity level of static shock. It can be adjusted from 0 to 3. The
default is 2.
Please refer to below table for intensity level setting:
Level
Intensity
Suit for Dogs
0
No Output
Non- training
1
Low
Small-size dogs
2
Medium
Medium-size dogs
3
High
Large-size dogs
ON/OFF Button
: Turn on or shut down the receiver
Press the ON/OFF button briefly to turn on. The LED Indicator will turn on and stay
Blue.
To turn Off, press the ON/OFF button. The LED Indicator will flash twice then turn
off.
LED Indicator:
This shows the working status of the receiver.
The LED indicator shows Blue when the receiver turns on. Once the receiver turns
off, the LED indicator flashes twice then goes off.
In training session, the LED indicator shows Blue and flashes once every second.
When the battery runs low, the LED indicator turns to Red, and flashes with its
operating state.
NOTE: When the battery is too low, the Red LED will flash for 2 seconds and then the
receiver will shut down. During the charging process, the LED indicator will remain
Red, and will turn Blue after the battery is fully charged.
How it Works
The receiver detects its distance away from the initial point, through GPS
technology. Once the current position of the dog exceeds the pre-set distance, the
receiver will automatically start the training mode and work periodically until the dog
returns to the safe area (within the pre-set radius). In a single training session, the
system program can be divided into 7 stages. The first two stages only issue warning
beeps. The following stages add a static shock to the warning beep. The static shock
increases its intensity each stage. After one session of training (the 7 stages), the
receiver will automatically stop working for 1 minute and then be ready for the next
training session. Once the dog returns to safe range, the receiver immediately will
stop training and return to standby mode.
