MGDVRs ACAP series, Инструкция по установке и эксплуатации

Страница: 28 / 63

27
MGDVRs
w w w .
MGDVRs
. c o m
.
RECEIVER: Choose PTZ camera
. PTZ ID: Choose ID of PTZ camera
. MANUAL SETTING: Select the serial port that the camera uses to connect to the computer.
Refer to camera manufacturer’s documentation to set these values.
. OPEN: Open the connection to take control of PTZ camera.
. ARROW, FOCUS, ZOOM, AP, SPEED: Test each function.
. A1, A2, A3: Test Extra feature of the PTZ camera. (Depending on protocol it might not
function.)
. MENU: Bring the PTZ camera menu (Depending on protocol it might not function.)
. TOUR: Tour the preset of camera.
. 0~9: Preset numbers (Combination of 2 digit, 1~99). Move camera to each preset position.
. DELETE: Delete position of PRESET Number.
. PRESET: Setup of waypoints can be done by doing the following:
1. Select a preset number to setup and click “Preset”.
2. Move the camera view to a desired location.
3. Click “Preset” again to finish.
. SCAN: Only available with camera that supports Auto Pan function.
START-Press START from the beginning position.
STOP-Press STOP at the ending position.
. SEND: Manually give Hex value and send it to the camera.
•
Detection area setting
-
Whole area:
Perform motion detection on the entire area.
-
Partial area:
Click "Add“, and select specific area(s) to detect motion. Up to 10 partial areas can be
selected, and they can be deleted by pressing “Delete All" button.