INST
ALLER'S
INSTRUCTION
INST
ALLER'S
INSTRUCTION
P20 OF 28
P19 OF 28
HANG THE UNIT INTO THE BRACKET
Lift the unit up by holding the two sides at the bottom but not the front panel.
Tilt the unit slightly towards the wall bracket to feel and try to put the slot hook on the unit into the bracket hang
(earing).
The unit is provided with an insulated drainage pipe (24" long), to fit on the sprout that protrudes from the lower
rear side of the unit, insert the
drainage hole.
The unit then can now be
pushed firmly against the wall.
Carefully inspect the
installation to ensure that the
insulating back panel fits
firmly against the wall and
there are no fissures at the
back of the unit.
DRAINAGE
To complete the drainage line, fit the drainage pipe on the drainage hole and push firmly into place (A).
A further extension pipe can be added, if necessary.
If the line drains into a vessel (tank or other receiver), this vessel should not be sealed and the drainpipe should
not remain immersed in the water.
The drain should flow in a downwards direction, as this is a gravity flow.
UNIT INSTALLATION
Installer must make sure the
drain pipe is connected tight
while is not kinked or clogged.
Must test, by put some water
into the DRAIN BASEPAN at
the unit bottom (at airflow
inlet), to ensure the water can
flow out easily, before
operating the unit. May need
to check from time to time for
any possible dirty substances
left in the drain pan or drain
line. Failure to do so may
cause water damage or
property damage.
A
YMGI, Engineered Comfort Products for A Sustainable and Efficient Green World !
Innovatively Engineered HVAC Products for Greener and Better Tomorrow
YMGI, Engineered Comfort Products for A Sustainable and Efficient Green World !
Innovatively Engineered HVAC Products for Greener and Better Tomorrow
DRAINAGE HOLE
The unit generates condensate that has to be extracted to
enable the unit to operate correctly. It is necessary to drill a
1" hole in diameter in the position shown in the paper
template. It is for the drain line to go downwards and have
o
a minimum downward inclination of at least 3 along its
length.
FASTENING THE BRACKET
wall studs
UNIT INSTALLATION
INSTALLING AIR DUCT & GRILLE
* Round the 8" wall hole.
* Trim or extend the air duct to the length needed.
* Fit the air duct inside the wall against the unit duct connection ports. It is good to put some insulation to avoid
possible vibration noise.
* Fill and seal the gaps.
* Screw down the grille and fasten it to the wall.
Standard Grille
(Optional Grille-1)
(Optional Grille-2)
Screw down the grille and fasten it to the wall
with the louver towards downwards, to keep from rain splashing
into grille/air duct/unit).
Once the mounting spot is properly selected, then need to fasten the wall mount bracket onto the wall.
Wall Mount on Dry Wall-Wood Studs
For dry-wall mounting where wall studs are 16" apart:
will need to make sure to securely fasten big and long
enough screws into the 2 columns of 4 screw holes with 16"
center-to-center distance, as illustrated in the picture hereof.
For brick or concrete wall mounting:
must securely
anchor big and long enough screws into the wall
through 4 columns of holes on the mounting bracket.
Wall Mount On Brick Wall
For other wall mounting:
will need to make sure the
wall bracket be securely fastened onto sturdy and firm
wall, to allow hold 140-150LBs of unit securely.
Suggested tools:
stud finder/locator, wood or
concerete drilling tools, level, and measuring tape.
