background image

MFJ-432 Voice Memory Keyer 

Recording a message 

Push the RECORD PLAY button.  The REC LED should light.  Press and hold the 
appropriate message button while speaking into the microphone.  Release the message 
button when the message is complete.  Pressing the PTT switch is unnecessary if using a 
microphone connected in the EXTERNAL MIC jack.  The radio will be keyed and the 
message will be transmitted over the air if the PTT switch is pressed. 

Re-recording the message replaces an existing message.  A re-recorded message will 
erase any messages that it overruns.  See the section entitled 

Message Memories

 for more 

detailed information. 

A feature allowing immediate cancellation of an outgoing message can be installed. This 
is accomplished by programming memory 4, and using it as a "cancel" button. 

To use memory four as a cancel OGM (out going message) button: 

1.) Place the Voice Keyer in the record mode. 

2.) 

Briefly

 tap memory button four. 

3.) Release the record button. 

This action records a very short burst of no audio in position 4. If the operator is playing 
any other memory, he or she can immediately silence the VK by tapping memory button 
four. 

Note:

 Tapping four to cancel will not stop the automatic repeat function of message one. 

Memory four 

will

 cancel the immediate memory one auto-repeat transmission, but 

the auto-repeat button must be released to prevent VK from trying to repeat 
message after the normal cycle time elapses. 

 

Playing a message 

Push the RECORD/PLAY button until the PLAY LED is lit.  Press the correct message 
button to play a message.  The XMIT button in the outward position allows the user to 
listen to a message without transmitting it.  Press and lock the REPEAT MSG 1 button to 
repeat message 1.  The MFJ-432 will play message 1 once and then start transmitting it 
over the air until the REPEAT MSG 1 button is released to the "out" position.  To change 
the delay time, a trimpot, labeled REPEAT DELAY, is accessible through a hole in the 
back panel.  A small slotted screwdriver can be used to adjust the trimpot. 

Отзывы:

Похожие инструкции для MFJ-432