MFJ-1622 Instruction Manual
Window Mount Antenna
3
Assembly
[ ] 1. Remove all Parts from the packing material. Check to see that all are present using the list
on page 1.
[ ] 2. Place the _”- 24 split lock washer onto the threaded end of the whip.
[ ] 3. Screw the antenna into the coupling nut (shown in Figure 1) located on top of the coil
assembly.
[ ] 4. Secure the antenna into the coupling nut using a 12mm wrench.
[ ] 5. Uncoil the coax cable to its full length.
[ ] 6. Measure 30 feet from the antenna end of the coax and mark this point with a piece of
tape.
[ ] 7. Begin 18 inches from the antenna winding the coax in a circle, 8-10 inches in diameter,
using the 30 feet measured in the previous step.
[ ] 8. Use the three black wire ties supplied to tie the choke coils together. Space the ties out
evenly around the circle. Figure 1 shows a picture of the finished choke.
[ ] 9. Insert the _” x 3 _” bolts into the threaded holes on the base plate approximately one
inch as shown in Figure 1.
[ ] 10. Place the spacer plate onto the bolts as indicated in Figure 1.
[ ] 11. Push one end of the safety rope through the rope hole as indicated in Figure 1. Tie a knot
on both ends of the rope to secure it.
ANTENNA
COUPLING
NUT
CHOKE
TAP
LOADING COIL
SAFETY ROP
E
SPACER
SCREW
S
WING NUT
Figure 1