your transmitter, it is best to use a SWR meter. Connect the MFJ-16010 as in
figure A.
Tune your transmitter for minimum SWR using the following procedure:
1. For each position of the Inductance switch, rotate the Capacitance control
for maximum noise.
2. Apply enough transmitter power to give adequate indication on your
SWR meter. Do not apply full power while tuning for minimum SWR.
3. Turn the Inductance control for a drop in SWR.
4. Adjust the Capacitance control for minimum SWR.
5. If minimum SWR is not achieved, increase or decrease the Inductance
control one position then adjust Capacitance until minimum SWR is
achieved. If arcing between capacitor plates occurs, increase or
decrease the Inductance control one position then adjust Capacitance
control for minimum SWR.
6. After minimum SWR is obtained, full power up to 200 watts output may be
applied to the MFJ-16010.
For receiving, repeat step 1 then adjust Capacitance control for maximum
nose or signal strength.