Settings
Pressing and holding Program, allows using the step switches to control the following MIDI-
and general features:
Row 1: MIDI-Channel 1-8; Row 2: MIDI-Channel 9-16 (only one channel to be selected)
Row 3 (only one setting possible):
1. 4 x monophonic (1st track w. selected MIDI-Channel, plus following 3 channels)
2. 4-voice-polyphonic (selected MIDI-Channel)
3. 3-voice-polyphonic / Row 4: (selected MIDI-Channel)
4. 2-voice-polyphonic / Row 3 and 4: Velocity (selected MIDI-Channel)
5. 2 x monophonic / Row 3: Velocity, Row 4: Modulation Wheel (CC#1)
6. 2 x monophonic / Row 3 and 4: Modulation Wheel (CC#1)
7. 2 x monophonic / Row 3 and 4: Velocity
8. 2 x monophonic / Row 3: Modulation Wheel (CC#1), Row 4: Velocity
Row 4 (all functions can be active simultaneously, set LED on/off to activate/deactivate):
1. OFF = gate, positive slope; ON = gate, negative slope
2. OFF = gate, 10 volts; ON = gate, 5 volts
3. OFF = held notes, ON = notes not held (row 1+2)
4. OFF = held notes; ON = notes not held (rows 3+4)
5/6 To set the quantize scaling, use buttons 5+6 in combination:
OFF/OFF= semitones; ON/OFF= whole tones
OFF/ON= pentatonic scale; ON/ON= hexatonic scale
7. OFF = darker LED base setting, ON = brighter LED base setting
8. OFF = darker step LED display, ON = bright step LED display
MIDI-Sync
URZWERG PRO can be synchronized as sync-master or sync-slave to other MIDI-compatible
units. Toggle between master- and slave-mode using the Sync Mode switch.
Transposing sequences
Sequences can be transposed globally within a range of 2.5 octaves using a MIDI-keyboard
[C1 (#36) to G3 (#67)]. Note that high transpose settings might reach the borders of your
sound generating source. Separate transposing of rows 1+2 and 3+4 is only possible using
inputs CV1+2In and CV3+4In.
MIDI-step-control
With the sequencer stopped, all steps can be stepped through using MIDI-note commands.
Note-number A3 (#69) will step through of all four sequences, while A#3 (#70) and B3 (#71)
treat rows 1+2 and 3+4 independently.
Note-numbers C4 (#72) to G4 (#79) jump to the individual step positions of all four
sequences. C4 = step 1, C#4 = step 2 and so on… This works for the active MIDI-channel
with all four sequence rows being addressed at the same time.
Using the next-higher MIDI-channel accesses the steps of the sequence rows independently:
Sequence 1 = C1 to G1, Sequence 2 = C2 to G2, Sequence 3 = C3 to G3 and Sequence 4 = C4
to G4.
Owner’s manual
MFB-URZWERG PRO
