BEFORE INITIAL USE
Remove all packaging. Carefully wipe the outer case with a soft damp cloth and dry it afterwards with a dry
towel. Do not immerse the appliance in water or any other liquid. Wash the comb accessories in warm soapy
water to remove any impurities that may have accumulated. Check for any damage that may have occurred
during transit. Do not use if the appliance is damaged in any way or if the supply cord is damaged. Immediately
contact the service details located at the beginning of this instruction manual.
PRE USE TEST
Fully unwind the supply cord and connect to a suitable 230-240 V ~ AC 50Hz power supply.
Switch the clippers on briefly to check operation of the cutting blades. The blades are oiled and set at factory
level before shipment and so should not need any adjustment. If they appear to need adjustment refer to
adjustment operation latter in manual. Once you are happy with the operation of the cutting blades you may
commence operation.
BLADE ALIGNMENT
The blades are factory set before leaving the factory.
The blades must be realigned after removal for cleaning.
To adjust blades, set the adjustment lever in the uppermost position (short cut position). Loosen the two securing
screws. Line up the upper and lower teeth point for point. The end of the top blade teeth should be approximately
1.2mm back from the top of the bottom blade teeth. Tighten the screws after aligning the blades.
OILING
To maintain your clipper in peak condition, the blades should be oiled every few haircuts. Place 2-3 drops onto
the blades and switch on for a brief period. Wipe excess oil with a cloth. Use the oil supplied.
Do not use hair oil, grease, oil mixed with kerosene or any solvent. The solvent will evaporate and leave thick
oil, which will put a load on the motor slowing down the blade motion.
If replacement oil is needed, the oil to be used is White Mineral Oil or similar. This should be available from you
local hardware store.
2
PARTS DESCRIPTION
1.
Hair Clipper Unit
6. Attachment Comb 3 (9mm)
2.
Comb
7. Attachment Comb 4 (12mm)
3.
Scissors
8. Oil Bottle
4.
Attachment Comb 1 (3mm)
9. Cleaning Brush
5.
Attachment Comb 2 (6mm)
10. Plastic Carry Case
3
