Version: 18/10/2016
Filename: NA-MHF-22-COD-E_version3.doc
© Meyrat SA 2017
19 / 25
6.3 Spindle assembly
Safety
!
ATTENTION!
During assembly (and disassembly) or moving of the spindle in the holder,
blows to the shaft or the sleeve of the spindle can destroy the spindle.
!
ATTENTION!
During the clamping of the electric spindle into a holder or a frame, be
careful not to deform the body of the spindle. This will lead to a great decrease in the
service life of the electric spindle. Also observe the prescribed clamping area. This area is
engraved on the spindle sleeve, delimited by 2 arrows.
Mounting position
The electric spindle can be mounted horizontally or vertically.
Preparation for assembly
Take the spindle out of its packaging and place it on a soft surface (for example wood, cloth,
cardboard, etc.).
Remove the anti-rust protection paper and clean the sleeve.
Apply a small amount of oil or grease to the sleeve in order protect against corrosion (sleeve/hollow
part of the spindle holder).
Clean the hollow part of the spindle holder in the machine.
