Meyer's 435 Tandem, Инструкция и каталог запасных частей

Страница: 14 / 52

Page 14 Model 435
HYDRAULIC END GATE OPERATION
FIGURE 5. HYDRAULIC END GATE SHOWN
CLOSED
1. Open the end gate with the tractor hydraulic
control, Figure 5, and slowly engage the tractor
PTO clutch. This can be done while traveling
forward to avoid a heavier application at the edge
of the field than desired. The end gate must be
completely open.
CAUTION
Do not operate apron chain without raising end gate
first. Failure to heed may result in equipment damage.
2. Once the end gate has been fully opened, bring the
PTO up to speed and start application onto the
field.
3. When the spreader is empty, stop the PTO and
disengage the hydraulic flow on the tractor so there
is no chain slat under the hydraulic end gate,
Figure 5. Then close the end gate.
4. A beater clutch at the beater gearbox will allow
“over run” when the PTO is stopped, preventing
damage to the tractor.
UNHOOK SPREADER FROM TRACTOR
1. Park the spreader, set tractor parking brake, and
turn off all power.
2. Park your spreader on level ground and place
blocks ahead of and behind the wheels before
unhooking from tractor.
3. Remove the PTO shaft from the tractor and the
hydraulic hoses.
4. Remove the jack hub pin and rotate the jack into
the vertical position and secure with the hub pin.
Lower the jack to remove load from the tractor drawbar
and unhook the hitch.
MANDATORY SAFETY
SHUTDOWN PROCEDURE
BEFORE unclogging, cleaning, adjusting, lubricating or
servicing the unit:
1. Disengage the tractor PTO.
2. Shut off the tractor engine, remove the Ignition key
and take it with you.
3. Wait for all movement to stop.
4. Remove the Telescoping PTO Drive and ALL
power connections from the tractor.
ONLY when you have taken these precautions can you
be sure it is safe to proceed. Failure to follow the
above procedure could lead to death or serious bodily
injury.