SEL INSTALLATION AND OPERATING INSTRUCTION MANUAL
WWW.MEYERPRODUCTS.COM
00122-517-01 SEPTEMBER 2009
OPERATING INSTRUCTIONS
1.
WHEN STARTING UP NEW EQUIPMENT, BE SURE EVERYONE IS STANDING CLEAR, WATCH
FOR ANYTHING THAT MAY REQUIRE SHUTTING SYSTEM DOWN. EQUIPMENT MUST BE
STARTED UP SLOWLY AND WATCHED FROM A SAFE DISTANCE. WATCH FOR ANYTHING THAT
MAY BE HITTING SOMETHING THAT IT SHOULD NOT BE HITTING, AND LISTEN FOR SOUNDS
THAT ARE ABNORMAL. CORRECT ANYTHING THAT IS ABNORMAL BEFORE CONTINUING USE
OF THE EQUIPMENT.
2.
BEFORE INSTALLATION, MAINTENANCE, CLEANING, OR REMOVAL OF SPREADER, ALL
INITIAL START UP:
motor when disconnected. The spreader is shipped with the interlock device in the disconnected position and
must be connected for operating the spreader.
opened, and slower as knobs are closed.
DANGER
,
ELECTRICAL CONNECTIONS MUST BE DISCONNECTED
.
(Left hand mounted spinner should turn in CCW rotation
as viewed from above spinner.
,
Auger should turn in direction which makes auger fliting appear to move towards trough dropout
opening.)
1.
Connect
electrical harnesses
to safety interlock, spreader and spinner.
2
.
Keep auger
and spinner knobs on
controller to zero
position.
3
.
Push power switch to
“ON” position.
4
.
Examine auger and spinner to see if they are functioning properly. (They will be operating slowly.)
6
.
Open knobs to other positions and check to see if spinner and auger operate faster as knobs are adjusted.
7
.
Shut
power switch to off
This spreader is equipped with a
elctrical
safety interlock device designed to interrupt
electrical
flow to the auger
5
.
Open control
knobs to other positions and check to see if spinner and auger operate faster as knobs are
PAGE 17
