BATTERY
POS
NEG
Black Ground
Red
"A"
Light
Adapter
"B" Harness
Power/Ground
Park &Turn
"C" Harness
To Plow Light
"A" "B"
"C"
White
Black
Blue (Reverse
Signal)
Orange to "B"
harness of light modules
32
35
37
38
39
40
41
42
50
51
53
54
40
41
54
52
K. Meyer M-1 Hydraulic Fluid Part No. 15134 may need to be added to reservoir and
bleed the Angle Cylinders, proceed as follows:
a. Remove Fill Plug from reservoir to add fluid during charging.
b. Operate the Angle cylinders (2) until they are filled with Meyer M-1 Hydraulic Fluid
and are not spongy.
c. Top off the unit to the fill line on the reservoir with Meyer M-1 Hydraulic Fluid.
NOTE: Proper fluid level is to the fill line on the reservoir for the E-72.
It must be checked with the lift cylinder fully retracted.
(S) terminal white wire
(I) terminal black wire w/white stripe
15059 Diode packed in Controller box
H. Run Universal Truck Side Harness (54) through a hole in grille and into the engine
compartment. Sandwich vehicle grill between Plug Bracket (37) and Plate (38) using
Bolt H 5/16-18 x 3” (42), 5/16 Lockwasher (40) and 5/16-18 Finish nut (41). Secure
Universal Truck Side Harness (54) to Plug Bracket (37) using Bolt H 5/16-18 x 1” (39),
5/16 Lockwasher (40) and 5/16-18 Finish nut (41).
Secure Universal Truck Side Harness (54) from any hot /
moving parts with tie wraps as needed.
I.
Drill a 1-1/4” Diameter Hole thru firewall to install split bushing (52) and extend the
harness into the cab of the vehicle. Fused lead from Universal Truck Side Harness (54)
must be attached to terminal in fuse panel that is activated only when the ignition key
is “on.”
J. Install Motor Solenoid (50) to metal surface in engine compartment using Self Tapping
Screws (51). (Solenoid must be grounded to operate). Attach Red Power Cable (54) to
a large terminal on Motor Solenoid (50). Attach Black Ground Cable (54) to negative
(-) terminal of battery. Attach Red Power Cable (35) to positive (+) terminal of battery
and remaining large terminal on Motor Solenoid (50). Attach small white wire from
harness (54) to small terminal (S) on Motor Solenoid (50). Attach small Black/white
stripe wire from harness (54) to small terminal (I)(ground) on Motor Solenoid (50) At
tach Blue wire to a reverse signal on the vehicle. The blue wire is sensing when the
vehicle is in reverse in order to operate HFP (Hands Free Plowing).
Hydraulic Solenoid Color Code:
OPERATION - SOLENOID COMBINATION
RAISE
- Motor So “B” Solenoid
LOWER
- “A” Solenoid Only
LEFT ANGLE
- Motor Solenoid Only
RIGHT ANGLE
- Motor So “C” Solenoid
COIL COLOR CODE
MOTOR SOLENOID
- WHITE WIRE
“A”
- BLACK WIRE
“B”
- RED WIRE
“C”
- GREEN WIRE
GROUND WIRE EACH COIL BLACK W/WHITE STRIPE
E-72 Fill level line
E-72 Fill Plug
(6)
Vehicle Side Wiring Diagram
