A. Attach L.H. and R.H. Light Brackets (47 & 48) to the side plates of Lift Frame
(12) in the upper two holes using 5/16”-18 x 1-1/4” bolts (56), 5/16” lockwashers
(57), and 5/16”-18 hex nuts (59).
Note:
Light brackets may be adjusted down two
levels in height for better appearance on lower profile vehicles. Tighten all fasteners
to their proper torque.
73
74
75
76
77
78
79
80
81
82
83
84
85
86
6
36
43-46
55
60
61
58
B. Liberally coat Pivot Pins (60 & 61) with Coolube Multi-Purpose Premium
Grease Part No. 15181.
C. Attach Pivot Bar (6) to Moldboard with Pivot Pins (60 & 61) (grease fitting facing
outward) and insert Cotter Pins (58). Grease outer Pivot Pin’s (52) using grease fitting.
9
7
15
24
34
11
10
16
22
34
1
33
9
10
11
2
3
4
5
6
8
12
13
14
17
18
19
21
2
3
4
20
23
25
26
27
28
29
30
31
23
23
23
23
26
47
48
49
62
63
64
56
57 59
20309
20530
07031
RIB
07017
D. Attach Eye Bolts (55) to Moldboard and Trip Springs (36) to Pivot Bar (6), making
certain locknuts are positioned as shown below.
E. Make certain each Eye Bolt (55) is in a vertical position as shown below so that the
Eye Bolt (55) and Trip Spring (36) hinge properly when moldboard trips.
Note:
Proper tension is attained when Trip Spring (36) coils just begin to separate
and then tightening top locknut four additional turns. Tighten bottom Locknut (20530)
to secure Eyebolt in position. Install Eyebolt caps (07031) over exposed threads.
F. Attach Plow Markers (43) to moldboard using 5/16-18 x
1” Bolt (44), 5/16” Flatwasher (46) and 5/16-18 Locknut (45)
(5)
G. Attach the Lift Chain to the Lift Arm (14) through the two hooks on the lift arm. Adjust
the lift chain at the lift arm so that there are 2-3 links of slack. This ensures that the
plow blade will lift fully and be able to follow the ground contour while plowing.
65
66
67
68
69
70
71
72
6
36
43-46
55
60
61
67
58
58
Attaching Plow to EZ Build Assembly