ASSEMBLY INSTRUCTIONS
2.
Slide
wheels onto the axle with the hub
cap side of the hup away from the hopper.
Note: the drive wheel has a rectangular
opening matching one end of the axle. Insert
cotter pins in the holes on each end of the
axle and bend to secure. Align the hub caps
and snap them into place.
1.
Remove the spreader and
components from carton and place
hopper facing on a padded surface as
shown. Insert lower ends of the handle
brace inside the hopper, align the holes
and attach the leg bracket using (2) 1/4-
20 x 1 1/2” Hex bolts and Wing Nuts.
Secure Leg to Bracket (Leg can be
located in 2 positions to best fit operator)
using (2) 1/4-20 X 1/2” Hex Head Bolts,
and Wing Nuts. Repeat on opposite side.
3.
Turn spreader upright and insert the
T-handle/tube assembly into the handle
with the ON/OFF on the T-handle facing
up. Align hole and insert the Carriage
Bolt as shown and secure with a Wing
Nut
.
Slide control wire through handle
brace removing the safety tag. Push the
thumb release toward the center and
push down on the control knob until it
latches. (See Fig.1) Caution: do not
move thumb release until bottom of
wire is attached.
3.
Slide the wire retaining clip onto the
bottom end of the control wire. Insert the “L”
end of wire through the hole in the shutoff
link. Slide wire retaining clip over the shutoff
link and protruding wire until the hole in the
clip seats over the wire as shown.
