SNOW PLOW WILL NOT ANGLE LEFT
Can the snow plow
Raise?
See the Raise
Flow Chart
Section
NO
NO
NO
YES
YES
YES
NO
Is there power to
the motor solenoid?
(White Wire)
Is there power
leaving the switch?
Are the wires in
molded connector
making contact with
the switch?
Are "C" Valve
O-Rings in good
condition?
Replace
Piston
Weld
1-1/2" x 1-1/2" x 1/2"
spacers to the A-Frame
stops.
Replace
O-Rings
Replace the
P.A. Block
YES
Will the snow plow angle
right & left if not allowed
to travel to extreme
angled position?
YES
Does the motor run
when angle switch
is pushed?
NO
Replace Harness
Replace Angle
Switch
NO
NO
Does the snow plow
angle to the right when
the angle switch is
pushed left?
Is the ampere draw
less than 100 amperes
while trying to angle
snow plow?
Can the snow plow be
angled by hand when
the P.A. Rams are
disconnected from A-Frame?
Does the snow plow
raise instead of
angling left?
NO
NO
Relieve the interference
between the
Sector and A-Frame.
NO
Clean or replace the
"C" Valve.
Retest
Is the Pilot piston in
good condition?
(worn/sloppy or Missing)
Clean or replace the
"B" Valve.
Retest
Does pressure remain
in angle hose when the
motor is not running?
NO
NO
YES
YES
YES
NO
Temporarily put 1/2" blocks
between the Sector and
A-Frame to limit the degree
of angle. Will the snow plow
now angle?
Replace both the
Coupler sets and/or
clean or replace the
"C" Valve.
If both hoses are stiff
inspect the Pilot Check
Piston and "C" Valve
for binding.
If one hose is stiff
inspect the the "C"
valve for binding.
Replace Coupler sets.
Clean or replace
the Crossover Relief.
Does the snow plow
now angle?
YES
YES
YES
YES
NO
YES
