INSTALLATION INSTRUCTIONS
Note: The following instructions cover assembly of
Moldboard, Sector and A-Frame. Refer to separate
instructions for installation of plow mounting and
hydraulic system.
a. Liberally coat Pivot Pins (25) with chassis lubricant.
b. Attach Sector (31) to Moldboard (1) with Pivot Pins
(25) and insert Hair Pins. Grease Pivot Pin using
grease fitting.
c. Attach Eye Bolts (27) to Moldboard (1) and trip
Springs (32) to Sector (31), making certain locknuts
(27) are positioned as shown in Figure 1.
d. Make certain each Eye Bolt (27) is in a vertical
position as shown in figure 2 so that the Eye Bolt
(27) and Trip Spring (32) hinge properly when
moldboard trips.
Note: Proper tension is attained when Trip Spring (32)
coils just begin to separate and then tightening top
locknut four additional turns.
e. Attach A-Frame to Sector (31) as shown in Figure 2.
IMPORTANT:
Install King Bolt (28) from bottom so
that locknut (27) is on top.
© 2003 Printed in the U.S.A.
18513 Euclid Ave. • Cleveland, Ohio 44112-1084
Phone 486-1313 (Area Code 216)
email [email protected]
www.meyerproducts.com
20309
20530
07031
RIB
A-Frame
Sector
King Bolt
FIGURE 1
FIGURE 2
TRIP SPRING
