Luminaire with 12 x 2,5 W
high performance - LEDs.
INSTALLATION INSTRUCTIONS
Connection of light fitting in compliance with the
prevailing regulations in your country.
Luminaire for non-protected, outdoor installation.
Luminaire is suitable for mounting on
normal inflammable building materials.
Luminaire
weight
projected area
Disconnect from power supply before opening
luminaire. Unscrew and remove the two clamping
plates. Observe label:
Prise open the polycarbonate cover as shown in
Image
using a screwdriver for slotted screws
. Insert the power supply cable
(
diameter) through the cable entry,
take the sheathing off the last 8 cm and put the
enclosed silicone sleeves over the ends of the
individual wires. Make electrical connection.
Tighten the cable entry gland. Place the edge of
the polycarbonate cover in the gasket groove and
apply pressure to the cover until it clicks into the
groove on the opposite side. Replace the
clamping plates and tighten screws with 4.5 Nm.
Partially tighten the screws in the mounting
brackets. After adjusting / aiming luminaire,
tighten the screws fully.
The mounting brackets must also be fixed by
tightening the grub screw .
Luminaire may be operated only when all
protective covers are in place.
8 707 0..
2,9 kg
0,06 m²
8 707 1..
3,4 kg
0,06 m²
A
on both sides
8.5 - 9.5 mm
B
Ensure that the minimum spacing between
luminaire and illuminated surface is observed !
F
B
MOUNTING
INSTRUCTIONS
.
Stemmessiepener Weg 5
D-58675 Hemer
Ecovision
Anbauleuchte
Luminaire
Schutzart - Protection IP 65
Schutzklasse - Safety Class I
t 25°C
a
min 0,2 m
100 mm Abstand ist immer einzuhalten.
A distance of 100 mm must always be observerd.
Glas öffnen
Open the glass
. ... ... 10. ( DALI )
. ... ... 20. ( 1-10 V )
A
8 707 0..
8 707 1..
8 707 0.. 10.
8 707 0.. 20.
8 707 1.. 10.
8 707 1.. 20.
8 707 0..
8 707 1..
8 707 0..
8 707 1..
