Meyer Sound MPS-488HP, Руководство по эксплуатации, Страница: 27 / 36

MPS-488HP OPERATING INSTRUCTIONS
27
2. Insert the five exposed conductors into the five cable holes in a Phoenix 5-pin male cable mount connector. Use the fol-
lowing wiring scheme.
3. Secure the conductors by tightening the five screws in the Phoenix cable mount connector. Screws should be torqued to
5–6 Nm (4.4–5.3 In-Lbs).
CAUTION: Screws should not be inserted into the Phoenix connector while the connector rests in a mating
plug. Doing so will damage the contacts. During assembly, the Phoenix connector should only be held in place
externally.
4. If the other (ECO-M) end of the cable has not been stripped, strip the outer shielding 1 inch and then strip the black, red,
blue, and white wires 0.100 inch.
5. Disassemble the ECO-M 7-pin female connector and feed the stripped cable through the pressing screw, pinch ring,
seal, angled hood, and sleeve.
Pin Destinations for Phoenix 5-Pin Male Cable Mount Connector
ECO-M 7-Pin Female Cable Mount Connector, Assembled (Left) and Disassembled (Right)
screws
Pin 5 White Audio signal (+)
Pin 4 Blue Audio signal (-)
Pin 3 Shield drain Audio shield
Pin 2 Red DC power (+)
Pin 1 Black DC power (-)
!
Pressing screw
Angled hood
Pinch ring
Seal
Sleeve Insert connector