Meyer Sound Compact VariO UPJ-1P, Руководство по эксплуатации

Страница: 30 / 32

24
APPENDIX B
Input level Audio source must be capable of producing a minimum of +20 dBV (10 V rms, 14 V pk) into
600
Ω
to produce maximum peak SPL over the operating bandwidth of the loudspeaker.
AMPLIFIERS
Amplifier type Two-channel complementary power MOSFET output stages (class AB)
Output power 300 W total
Note:
Wattage rating is based on the maximum unclipped burst sine-wave rms voltage the
amplifier will produce into the nominal load impedance — low and high channels 30 V rms
(42 V pk) into load impedance
THD, IM TIM < .02%
Load capacity 4
Ω
low channel, 16
Ω
high channel
Cooling Forced air cooling over amplifier heatsink
AC POWER
AC power connector PowerCon with looping output
Voltage selection Automatic
Safety agency rated
operating voltage
100 V AC - 240 V AC; 50/60 Hz
Turn on/turn off points 90 V AC to 264 V AC; 50/60 Hz
Note:
No automatic turn-off voltages. Voltages above 265 V AC are fuse protected but
may cause permanent damage to the power supply. Voltages below 90 V AC may result in
intermittent operation.
Current Draw
Idle current 0.41 A rms (115 V AC); 0.33 A rms (230 V AC); 0.42 A rms (100 V AC)
Max. long-term continuous
current (>10 sec)
3.2 A rms (115 V AC); 1.6 A rms (230 V AC); 3.7 A rms (100 V AC)
Burst Current (<1 sec) 5.0 A rms (115 V AC); 2.5 A rms (230 V AC); 5.8 A rms (100 V AC)
Note: Current draw for a single loudspeaker. Loop out not used.
Ultimate Short-Term Peak
Current Draw
17 A pk (115 V AC); 8.5 A pk (230 V AC); 20 A pk (100 V AC)
Inrush Current 15 A pk (115 V AC); 13 A pk (230 V AC); 15 A pk (100 V AC)
PHYSICAL
Enclosure Multi-ply hardwood
Finish Black textured
Protective grille Powder-coated hex stamped steel
Rigging QuickFly rigging options
Dimensions 11.15" W x 22.43" H x 12.25" D (283 mm x 570 mm x 311 mm)
Weight 46.00 lbs (20.87 kg)
�����
���������
�����
���������
����
���������
�����
���������
����
���������
����
���������
�����
���������
�����
���������